Furuno felcom 12 service manual

15 About This Manual. Antenna Unit; Communication Unit; Terminal Unit; 16 FELCOM 12 System Configuration; 17 INMARSAT -C SYSTEM. Introduction. 20 Figure 3 Coverage area of satellites; 21 Communications Network. 22 Types of MES; 23 Peripheral Equipment. Distress/Urgent Receiving Unit (IC) Distress Alert Unit (IC) Distress Message. I/F box IC (for FELCOM 12) FELCOM 12 is connected to the SSAS Alert Unit via the I/F Box IC For detailed wiring refer to the interconnection diagram at the back of this manual. 15 mm 40 mm Cut and tape unused wires to prevent short. CO-SPEVV-SB-C X5P or TTYCS-4 Twist shield. Clamp for cable TTYCS-4 (or equivalent) Clamp for cable.  · • The operator of this equipment must read and follow the descriptions in this manual. Wrong oper-ation or maintenance can cancel the warranty or cause injury. • Do not copy any part of this manual without written permission from FURUNO. • If this manual is lost or worn, contact your dealer about replacement.

• The operator of this equipment must read and follow the descriptions in this manual. Wrong oper-ation or maintenance can cancel the warranty or cause injury. • Do not copy any part of this manual without written permission from FURUNO. • If this manual is lost or worn, contact your dealer about replacement. The FELCOM 12 will search for that NCS signal each time it is turned on. The Auto setting searches all NCS signals to find the most suitable NCS; thus, scanning can take quite some time. (For reference, the coverage range of each satellite is shown in the figure on page 8.). service manual. Only qualified personnel should work inside the equipment. WARNING Turn off the power at the mains switchboard before beginning the installation. Post a sign near the switch to indicate it should not be turned on while the equip-ment is being installed. Fire, electrical shock or serious injury can result if the power is left on or is applied.

8/12/ Inmarsat-c Furuno Felcom Manual 1//12/ Inmarsat-c Furuno between units in case of multiple unit installation, change jumper block. FELCOM 16, operating from +12 to +24 VDC, consists of a communication unit and an antenna unit. A PC with the terminal software is used as a terminal unit. ・FURUNO Authorized Distributor/Dealer Ashihara-cho, Nishinomiya, How to check the program number of FELCOM 18/19 Refer to Service manual of FELCOM.